How to add and reset CREE LED Bulb on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset CREE LED Bulb on Hubitat Elevation hub

2. Resolution

Factory Reset

1. Turn ON the bulb > pause 1 seconds > turn OFF the bulb > pause 2 seconds > Turn ON the bulb > pause 1 seconds > turn OFF the bulb > pause 2 seconds > Turn ON the bulb > pause 1 seconds > turn OFF the bulb > pause 2 seconds > Turn ON the bulb
2. The bulb will flash once, indicating it is reset and ready for pairing

Factory Reset (Alternate Method)

• Method 1 - Use a Philips Hue Dimmer Switch

1. Turn the bulb on (ensure there are no others in the same lamp, as they could be reset too, using this method).
2. Hold the remote within 4 inches of the bulb.
3. Press and hold the 1st (On / I in some countries) and the 4th (Off / O in some countries) buttons simultaneously for about 10 seconds, until the bulb starts flashing on and off.
4. If the bulb stopped flashing (it will normally turn fully on again after reset) and the green LED on the remote (top left of the remote) flashed green - your bulb is reset.
5. This method can be used for nearly ALL ZigBee LL bulbs.

• Method 2 - Use a Lutron LZL-4B Connected Bulb Remote (Discontinued Product)

1. Hold the remote within 4 inches of the bulb.
2. Press and hold the 2nd (up arrow) and 4th (light off) buttons simultaneously.
3. The bulb should flash on and off
4. The green LED on the remote should come on and may flash a few times.
5. Continue to hold both buttons on the remote until the green LED goes off completely.
6. This method can be used for nearly ALL ZigBee LL bulbs.

Join the Zigbee Network

1. From the Hubitat Web Interface home page, select Zigbee on the Device Discovery page to start device discovery.
2. Turn ON the bulb > pause 2 seconds > turn OFF the bulb > pause 2 seconds > Turn ON the bulb > pause 2 seconds > turn OFF the bulb > pause 2 seconds > Turn ON the bulb > pause 2 seconds > turn OFF the bulb > pause 2 seconds > Turn ON the bulb
3. The bulb will flash once, indicating it is reset and ready for pairing

Join the Zigbee Network (Alternate Method)

1. From the Hubitat Web Interface home page, select Zigbee on the Device Discovery page to start device discovery.
2. See Factory Reset (Alternate Method) above to reset the bulb and put it into pairing mode.

Leaving the Zigbee Network

1. From the device's details page, select Remove Device, then Remove.

Brand

Device

Device Type

Protocol

CREE

Connected LED Bulbs

Bulb

Zigbee