How to add and reset First Alert products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset First Alert products on Hubitat Elevation hub

2. Resolution

Factory Reset

1. Power up the device with the test button held down for 10 or more seconds
2. The device will reset all Z-Wave settings and leave the network. NOTE: The device will not remain awake after resetting and will go into standby mode.

Join the Z-Wave Network

1. Slide battery door open and insert batteries.
2. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
3. Press and hold the test button. Keep it held down as you slide the battery drawer closed. You may then release the button and the alarm will remain awake for 30 seconds on inclusion.

Exclusion from the Z-Wave Network

1. From the device's details page, select Remove Device, then Remove
2. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
3. Slide battery door open, then remove and re-insert batteries.
4. Press and hold the test button. Keep it held down as you slide the battery drawer closed. You may then release the button and the alarm will be excluded from the network.

Device

Product Number

Device Type

Protocol

Smoke & Carbon Monoxide Combo Alarm

ZCOMBO-G

Smoke / CO Detector

Z-Wave