How to add and reset GoControl products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset GoControl products on Hubitat Elevation hub

2. Resolution

Includes Linear GD00Z-2, GoControl GD00Z-4, Linear GD00Z-5, ADT GD00Z-6, GoControl GD00Z-7 and NuTone ND00Z

Factory Reset

1. Reset the controller by pressing the Link button 5 times.
2. A quick beep followed by a longer beep will indicate proper reset for the GD00Z series or ND00Z.

Join the Z-Wave Network

1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
2. Press and release the Link button.

Exclusion from the Z-Wave Network

1. From the device's details page, select Remove Device, then Remove
2. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
3. Press and release the Link button.

Brand

Device

Product Number

Device Type

Protocol

GoControl

Garage Door Controllers

GD00Z

Garage Door Opener

Z-Wave

Brand

Device

Product Number

Device Type

Protocol

GoControl

Door / Window Sensor

WADWAZ-1

Contact Sensor

Z-Wave

Factory Reset

1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
2. Press the program switch of WADWAZ-1 for 1 second and release. The LED light will flash continuously when the sensor has been successfully excluded.

Join the Z-Wave Network

1. Unscrew the screw fastening the rear cover and slide the rear cover down
2. Insert a CR123A battery into the battery compartment and LED will start to flash slowly, which means the sensor has not yet performed inclusion with the controller.
3. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
4. Once Hubitat Elevationâ„¢ discovers the device, the LED will stop flashing. If the LED does not stop flashing and is not discovered by your hub, relocate the WADWAZ-1 to within 100 feet (line of sight) of a Z-Wave repeater or your hub and restart Z-Wave Inclusion.

Exclusion from the Z-Wave Network

1. From the device's details page, select Remove Device, then Remove
2. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
3. Press the program switch of WADWAZ-1 for 1 second and release. The LED light will flash continuously when the sensor has been successfully excluded.