How to add and reset Hampton Bay products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset Hampton Bay products on Hubitat Elevation hub

2. Resolution

Factory Reset

1. Turn off your fan for 3 seconds, then turn it on for 3 seconds (Repeat 5 times)
2. The light will flash three times when the factory reset is successful.

Join the Zigbee Network

1. From the Hubitat Web Interface home page, select Zigbee on the Device Discovery page to start device discovery.
2. Turn on your fan.
3. When successful, the fan will turn on at low speed and the light will flash three times.

Leaving the Zigbee Network

1. From the device's details page, select Remove Device, then Remove
2. Perform a factory reset on the fan controller

Device

Product Number

Device Type

Protocol

Wink Enabled Ceiling Fan Controller

MR101Z

Fan Controller

Zigbee