How to add and reset Telldus products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset Telldus products on Hubitat Elevation hub

2. Resolution

Factory Reset

1. Plugin the device.
2. Press and hold the button until the LED starts flashing white after approximately 6 seconds.
3. Short-press the button once more.
4. The device will now reset to factory defaults and the LED will flash red, indicating that it’s no longer part of the Z-Wave network.

Join the Z-Wave Network

1. Plugin the dimmer module.
2. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
3. Press the button 3 times within 1.5 seconds to enter inclusion mode.

Exclusion from the Z-Wave Network

1. Plugin the dimmer module.
2. From the device's details page, select Remove Device, then Remove.
3. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
4. Press the button 3 times within 1.5 seconds to enter exclusion mode.

Device

Product Number

Device Type

Protocol

Plug-in ON/OFF switch

TZWP-100

Switch

Z-Wave